Echo-bear-cat SC2170 User Manual Page 9

  • Download
  • Add to my manuals
  • Print
  • Page
    / 21
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 8
2 INCH CHIPPER/SHREDDER
5
ENGLISH
Section
ASSEMBLY
2
2.1 ATTACH WHEELS & AXLE
Attach wheels to the axle with two 5/8 X 3 1/4" bolts and
5/8" washers. Bolt the axle on to the chipper body with
four 5/16" X 1 3/4" carriage bolts and ange nuts.
BOLT, 5/8 X 3-1/4 HEX
WASHER, 5/8 FLAT
NUT, 5/16 NYLOCK
WASHER, 5/16 FLAT
BOLT, 5/16 X
1-3/4 CRG
2.2 HOPPER ATTACHMENT
Place hopper assembly on machine (as shown in Figure
2.2) and secure with six 5/16 x 3/4" serrated ange bolts
and 5/16 nuts.
ECROU, 5/16
BOULON, 5/16 X 3/4 PO.
2.3 FILL THE TANK
WARNING
Gasoline and diesel fuels are highly
ammable and their vapors are explosive. To
prevent personal injury or property damage:
Store fuel only in approved containers, in
well ventilated, unoccupied buildings, away
from sparks or ames. A container with a capacity of 2
gallons or less with a pouring spout is recommended.
Do not ll the fuel tank while the engine is hot or running,
since spilled fuel could ignite if it comes in contact with
hot parts or sparks from ignition. Do not start the engine
near spilled fuel. Never use fuel as a cleaning agent.
DO NOT MIX OIL WITH FUEL.
Use only those types of fuels that are recommended in
your engine owner’s manual.
To add fuel:
1. Stop engine, wait for all parts to stop moving and
disconnect spark plug wire. Remove key from key
switch. Allow the engine and muffler to cool for at least
three minutes.
2. Clean area around fuel fill cap and remove cap.
3. Using a clean funnel, fill fuel tank to 1/2” below bottom
of filler neck to provide space for any fuel expansion.
Install fuel fill cap securely and wipe up any spilled
gasoline.
Check the oil level and if needed ll the engine crankcase
with the type and amount of oil specied in the engine
owners manual.
2.4 CHECK/ADD MOTOR OIL
Figure 2.1
Figure 2.2
Page view 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 20 21

Comments to this Manuals

No comments